Funny…I was at the barber the other day and he kept complaining about his shears locking up…pesky scissors keep jamming on me he said! Well…obviously this is nothing but banal witticism, because that’s surely not what this article is about. I draw your attention to an experience I had regarding a fabric drapeability study that I performed inorder to evaluate fabric compliance over non-developable tool geometry…huh…bear with me. First the basics, when draping a composite fabric (or tape) over a tool, particularly a tool with compound curvatures, it is incumbent upon the designer to check for wrinkling and/or bridging in the fabric; especially near a radius or doubly curved surfaces. Fabric distortions of this type are clearly undesirable, and often yield poor laminate performance in terms of stiffness and lower than expected margins.
Technical Articles and Engineering Guidance
Engineering guidance for the contemporary engineer. Technical articles that can be leveraged by the practicing engineer at work to facilitate or enhance design and analysis endeavors.
Posts tagged 'fabric'